Planeplotter trimtree install#
Planeplotter trimtree download#

This allows aircraft to be located even if they are not equipped with ACARS or Mode-S/ADS-B. PlanePlotter can determine and display the direction of any transmission using a simple passive antenna switch. It can even give you a dynamic real-time view from the flight deck of an aircraft that you designate. If you are receiving Mode-S ADS-B position reports, PlanePlotter can interface to Google Earth to display aircraft positions over the Google Earth base map. Where altitude information is available (eg Mode-S messages), you can select the data by altitude band to distinguish low level and high level traffic.

Planeplotter trimtree download#

The plot can be superimposed on a suitable aeronatical chart that you have prepared, or PlanePlotter can download satellite imagery and plot the aircraft symbols on that. These include embedded position reports, AMDAR reports and ADS reports contained in ACARS messages, ADS-B position reports received by the Kinetic SBS1(tm) or AirNav System RadarBox(tm) Mode-S receivers, and position reports on HF using Charles Brain's PC-HFDL software. PlanePlotter plots aircraft positions, altitudes and times decoded from the message traffic that it receives. PlanePlotter archives all the digital data that it receives and decodes to a log file. PlanePlotter shows a table display of messages received and decoded from live aircraft transmissions. The animated screen grab from PlanePlotter (left) was kindly provided by John Locker. Using PlanePlotter, you can see a radar-like display of all those aircraft around you that are transmitting the appropriate digital messages including ACARS, ADS-B and HFDL.

Please bear in mind that the RTL dongle cannot perform as well as a dedicated Mode-S receiver but with a price tag that may be less than a tenth of other receiver types, it enables you to try the system with your own local data.PlanePlotter receives and decodes live digital position reports from aircraft and plots them on a chart. You can then start PlanePlotter processing and you can try performing the GS/MU test in the Help dialog ( networking) to check that raw data is being provided. In PlanePlotter, as well as defining the receiver type as 'RTL dongle', to be a Ground Station you will also need to enable 'Raw data' - both in the /O settings dialog. Which enables the Mlat clock, starts processing and minimizes the RTL1090 utility. If you want to automate the starting of RTL1090, you can use the command line : In the data box and then press the Start button. Having started RTL1090, make sure that you see the remark :

To turn on the time tags that are required for Mlats. To do that, you have to start RTL1090 with the following command line switch : If you have build 62 of RTL1090, the RTL dongle can also be used as a Ground Station. You will find the RTL dongle selection at the end of the list of receiver types in the /O settings dialog. This version includes support for Andy's RTL1090 utility driving the RTL dongle. If you have a version-specific firewall (eg Zone Alarm), you may have to reassure it that the new version is permitted to access the Internet. If you post a message saying that the installer is unable to replace planeplotter.exe, it means that you did not close PP first and you pay a forfeit.

Planeplotter trimtree install#

You can install the new version over the old one but you *must* close/exit PlanePlotter before installing the new one. If you post a message saying that the web site is still pointing to an earlier version, you pay a forfeit. You may need to exercise your browser Refresh function to force it to show you the new version of the PlanePlotter web page.

PlanePlotter version 6.3.2 is now available for download following the link on the the web site.